Meyer SXI 720, Owner/Operator’S Manual & Parts Book, Page: 41 / 132

1-800-325-9103
PB-SXIC - 41 - www.meyermfg.com
8.1.4 Break-In Lubrication (First 360-500 Loads*)
Change oil in the (3) gearboxes. Lubricate the (3) rear gearboxes with Synthetic EP Gear SAE 90/ISO220 oil,
capacity approximately 81.2 oz.
8.1.5 Semi Annual Lubrication
(865 with brake system only) See Merritor manual for brake component greasing.
8.1.6 Annual Lubrication
Change oil in the (3) gearboxes. Lubricate the (3) rear gearboxes with Synthetic EP Gear SAE 90/ISO220 oil,
capacity approximately 81.2 oz.
Clean and repack the wheel hubs with axle grease.
8.1.7 Automatic Chain Oiler
The automatic chain oiler attachment gives a squirt of clean oil to all roller chains every time that the spreaders rear gate,
hydraulic cylinder is activated. In this way, the spreaders roller chains get oiled in direct proportion to the number of
hydraulic cylinder cycles of the rear gate. This assures adequate lubrication.
New 30 weight oil, which is placed in the reservoir tank mounted on the spreader is all that is needed to properly lubricate
all roller chains and sprockets. The automatic chain oiler does not use any oil from the tractor’s hydraulic system. The
hydraulic hose connected to the bottom of the oiler pump only serves to power the piston in the pump every time that the
spreader’s rear gate is opened.
L3
L26
L3
L21
Shutoff and lockout power before performing machine service,
adjusting, maintaining, or clearing an obstruction from this machine.
Refer to section 5.3 SHUTOFF & LOCKOUT POWER.
Hydraulic fluid escaping under pressure can have sufficient force to
cause injury. Keep all hoses and connections in good serviceable
condition. Failure to heed may result in serious personal injury or death.