Meyer Boss 8200 RT, Owner/Operator’S Manual & Parts Book, Page: 32 / 100

Meyer Manufacturing Corporation - 32 - PB-8200-19
7.2 FRONT UNLOADING
NOTE: Unloading is best observed from the operator’s seat.
NOTE: The front of the forage box is open or is equipped with a plexiglass window to monitor forage level from
the operator’s seat.
Truck Mount: Make sure the selector valve knob is in the pulled
out position.
To start the cross conveyor, engage the tractor / truck
hydraulics.
Allow the cross conveyor to clean out.
Turn knob on the controller so the apron speed is at “0”.
Next, flip the switch to “Auger Start” to start the rotation of the
augers.
NOTE: This switch can be turned on & off to initially free the
augers of forage.
Last, turn the apron speed up to feed the augers and adjust for
a good feed rate. When the load nears the end, increase the
apron speed for fast clean out.
When you are finished unloading, turn the apron speed dial to “0”.
Next, turn the switch to “Power Off” the augers.
Last, disengage the tractor / truck hydraulics to stop the cross conveyor.
Shutoff and lockout power before adjusting, servicing, maintaining,
or clearing an obstruction from this machine. Failure to heed may
result in serious personal injury or death.
Never enter the forage box without shutting power “OFF” to the
machine. (See 5.4 SHUTOFF & LOCKOUT POWER on page 22.)
Never use “LIVE” power to aid in the clean-out of a clogged machine.
The unloading process described is to be performed by the operator
alone. This will eliminate unexpected “start-ups” and minimize other
hazards that could result by more than one person in control.
CONTROL BOX
If the forage box becomes clogged, shut off all power to the forage
box and wait until all rotating components are completely stopped.
(See 5.4 SHUTOFF & LOCKOUT POWER on page 22.)
If any component fails, shut off all power to the forage box and move
the forage box to a safe work area. Repair or replace damaged
components before proceeding with unloading of the forage.