Meva MGC-F, Technical Instruction Manual

Page: 9 / 30

MGC-F
w
9
Technical Instruction Manual / May 2022
MGC-F
Installation of the climbing cones
Description Ref. No.
Anchor plate
15/120 .......................
29-412-30
15/170 ....................... 29-412-35
20/170 ....................... 29-412-37
Climbing cone
15/M24 .......................
29-412-70
20/M24 ....................... 29-412-75
Conical sleeve ............. 29-412-95
Positioning disc M24 ... 29-412-85
Climbing shoe MGC .... 29-011-50
Climbing shoe MGC with
swivel-guide ..............
29-011-60
Washer D40xD26x4, galv.
DIN 1440-26 ................
29-412-78
Hexagonal screw M24x60,10.9
black, ISO 4017 ...........
63-119-48
Anchor plate
Conical sleeve
Climbing cone 15/M24
Positioning disc M24
Climbing shoe
Facing
Washer D40xD26x4
Hexagonal screw M24x60, 10.9 black, ISO 4017
(DO NOT USE GRADE 8.8 OR LOWER GRADE BOLT)
Fig. 9.5
Fig. 9.2
Fig. 9.1
Possible installation methods of the
climbing cones at the formwork
Installation with M24x60 bolt
(Fig.
9.1
and
9.2
)
Use this method when the climbing cones always have
the same location as it ensures a dimensionally
accurate installation.
Installation with positioning disc M24
(Fig.
9.3
and
9.4
)
Important
The accurate installation of the anchoring material is mandatory. Inaccurately placed
anchors or anchors that have moved during concreting
MUST NOT BE USED.
Hexagonal screw M24/60
Fig. 9.4
Fig. 9.3
Positioning disc M24
1. Screw the M24x60 bolt through the pre-drilled hole (Ø1 inch)
in the form face into the climbing cone.
2. Install the conical sleeve onto the climbing cone. This will
ease unscrewing the climbing cone after stripping the formwork.
3. Screw the anchor plate into the climbing cone.
4. Support back edge of anchor plate by wiring to rebar. (Fig. 9.2)
5. Before stripping the formwork, remove the M24x60 bolt and
detach the formwork from the concrete.
1. Cover the Allen key recess of the positioning disc with tape.
2. Attach the positioning disc with 4 nails to the facing. (DO NOT
USE DOUBLE HEADED NAILS)
3. Screw the climbing cone onto the positioning disc.
4. Install the conical sleeve onto the climbing cone. This will ease
unscrewing after stripping the formwork.
5. Screw the anchor plate into the climbing cone (Fig. 9.3).
6. Support back edge of anchor plate by wiring to rebar.(Fig. 9.4)
7. After stripping the formwork, unscrew the positioning disc
from the climbing cone using an appropriate Allen key.
wire loop
for support
wire loop
for support
8
8
8
7
7
4
4
6
6
6
1
1
1
1
3
3
3
3
2
2
2
5
5