3
Installation
page 4
ELC X-Series-V1.3-09.16-GB
subject to technical alterations
3 Installation
3.1 Mounting of casing
The ELC may only be installed as described in 3.1.1 and in 3.1.2, allowing for at
least
the
minimum
spacing
as
shown
in
Fig.
2.
Horizontal mounting upside down is not allowed. All vertical mounting orientations
are possible.
The ELC should not be mounted in the immediate proximity of sensitive electronic
equipment. An appropriate distance must be maintained to scatter field
transformers or other inductors.
The ELC is equipped with built-in fans to ensure forced air cooling. Air ducts and
optional filters must be designed to allow the air flow described in chapter 6. The
ambient temperature must not exceed the values described in chapter 6. The
ambient temperature is measured by the ELC and will be stored within the internal
error memory.
3.1.1 Mounting of single ELC
The side surfaces of the housing contain 2 T-slots each, which are suitable for sliding blocks
6mm groove, M5 by Bosch Rexroth (available as accessories). Fig. 1 indicates the relative
interspace of the two T-slots and distance to the outer face of the housing. Fig. 2 shows the
horizontal mounting orientation including the minimum spacing at the back of the ELC.
Alternatively the ELC may be mounted flush with the rear panel if a cut out for the ventilation
is ensured.
Fig. 1:
Position of the T-slots
☞
☞