Metrohm Titrino 719 S, Instructions For Use Manual

Page: 92 / 152

3.2. Remote control commands
719 S Titrino
88
3.2.2.66. I nfo .A ctualInfo .A ssembly .Co unter .V read only
I nfo .A ctualInfo .A ssembly .Co unter .C lear $G
$Q sends the volume. With the function &Info.Assembly.Counter.Clear $G, the
volume counter is set to zero.
3.2.2.67. I nfo .A ctualInfo .A ssembly .M eas read only
I nfo .A ctualInfo .A ssembly .P istonPos read only
$Q sends the current measured value from the assembly.
Piston position: 0 = initial position (filled)
10 000 = end position (empty)
3.2.2.68. I nfo .A ctualInfo .T itrator .C yclNo read only
I nfo .A ctualInfo .T itrator .V read only
I nfo .A ctualInfo .T itrator .M eas read only
I nfo .A ctualInfo .T itrator .d Vdt read only
I nfo .A ctualInfo .T itrator .dM easdt read only
I nfo .A ctualInfo .T itrator .dMeasdV read only
$Q sends the current values in the following formats:
SET MEAS CAL
CyclNo 127 127 127
V(ml) 1.2345
- -
Meas:
pH
U, Ipol (mV)
Upol (uA)
T (°C)
3.6(mV)
-345.6
-12.5
-
3.345
-345.6
-12.5
25.0
3.345
-
-
-
dVdt (ul/s) 2.5142 - -
dMeasdt
pH,U,Ipol mV/s
Upol (uA/s)
T (°C/s)
0.7957
0.7957
-
0.7957
0.7957
0.7957
0.7957
-
-
dMeasdV (mV/ul) 10.6326 - -
NV: Not Valid. If in the signal drift is OFF in modes MEAS and CAL, the signal
drift is NV.
OV will be sent for "overrange".
A time frame can be set up from the cycle number and the cycle time (see
3.2.2.71). The cycle number is set to 0 at the start of a method and it is in-
cremented until the end of the method.
3.2.2.69. I nfo .A ctualInfo .E P .I ndex read only
I nfo .A ctualInfo .E P .X read only
I nfo .A ctualInfo .E P .Y read only
.EP.X"1.234" Volume coordinate of the EP
.EP.Y"5.34" Measured value coordinate of the EP
3.2.2.70. I nfo .A ctualInfo .D isplay .L 1 up to 24 ASCII characters