3.8 Connecting MSB devices
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
24
￭￭￭￭￭￭￭￭
919 IC Autosampler plus
3.8.2
Connecting a stirrer or titration stand
You can use the following instruments:
These devices have a built-in magnetic stirrer (stirring "from below"):
￭
801 Stirrer
￭
803 Ti Stand
This device has no built-in magnetic stirrer (stirring "from above"):
￭
804 Ti Stand with rod stirrer 802 Stirrer
Connect a stirrer or a titration stand as follows:
1 Connecting the stirrer or titration stand
￭
Exit the control software.
￭
Connect the connection cable of the magnetic stirrer or of the
titration stand to one of the sockets marked with
MSB
on the
rear of the control instrument.
￭
804 Ti Stand only: Connect the rod stirrer to the stirrer connector
(socket with stirrer symbol) of the titration stand.
￭
Start the control software.
USB 1
Contr.
MSB 2
MSB 3
Figure 14
Connecting an MSB stirrer
Figure 15
Connecting the rod stirrer to the titration stand
