Autolab/Electronic load combination
7 |
P a g e
Figure 2 – Two versions of the Dynload interface (left – general purpose interface, right – for
Kikusui electronic loads)
The three SMB shielded cables can be fitted with SMB to BNC adaptor plugs.
Depending on the type of FRA module used in combination with the LED Driver,
these cables can be modified accordingly:
•
For the FRA2 module, the cables must be fitted with SMB to BNC adaptors
on both ends (see Figure 3).
Figure 3 – Configuration of the SMB cables used in combination with the FRA2 module
•
For the FRA32M module, the cables must be fitted with SMB to BNC
adaptors on a single end (see Figure 4).
DYNAMIC LOAD
External prog.
DAC-1
DSG
Y-FRA/ADC
I-M
15 V
+
-
To back panel of electronic load
DYNAMIC LOAD
DAC-1
DSG
Y-FRA/ADC
Dynamic load
15 V
+
-
Dynload
FRA Y
Dynl DSG
FRA V
E-out
FRA X
