2.1
Instrument setup
853 CO
2
Suppressor / Instructions for Use 8.853.8001EN
7
2 Installation
2.1 Instrument
setup
2.1.1 Packaging
The 853 CO
2
Suppressor and its separately packed accessories are
supplied in very protective special packaging. Please store all this spe-
cial packaging; it is the only way in which the safe transport of the
instrument can be guaranteed.
2.1.2 Checks
Please check that the delivery is complete and undamaged immediate-
ly on receipt (compare with delivery note and list of accessories given in
Section
). If transport damage is evident please refer to the informati-
on given in Section
"Warranty".
2.1.3
Arranging the instruments
Place the 853 CO
2
Suppressor next to the detector block in the Com-
pact IC. With a modular system, place it in the Separation Center, like-
wise next to the detector block.
2.2 Mains
connection
The 853 CO
2
Suppressor is provided with a 15 V power supply from an
external power supply (6.2152.020).
1 Connection 853 – Power supply
•
Connect the external power supply (6.2152.020) to the 15V
connection "
15V DC
" of the 853 CO
2
Suppressor.
2 Mains connection
•
Plug the mains cable into the connection on the external power
supply (6.2152.020), and connect it to the mains supply (100-
240 V).
Mains cable
The instrument is supplied with one of the following mains cables
•
6.2122.020 with SEV 12 plug (Switzerland,
…
)
•
6.2122.040 with CEE(7), VII plug (Germany,
…
)
•
6.2133.070 with NEMA 5-15 plug (USA,
…
)
which has three wires and is fitted with a plug with a grounding pin. If a
different plug has to be used then the yellow/green wire (IEC standard)
must be connected to the grounding pin (Protection class
I
).
Summary of Contents for 853 CO2 Suppressor
Page 1: ...853 CO2 Suppressor Manual 8 853 8001EN ...
Page 2: ......
