Metrohm 785 DMP Titrino, Instructions For Use Manual

Page: 47 / 182

2.10. Data output
785 DMP Titrino
44
2.10 Data output
2.10.1 Reports for the output at the end of a determination
With <DEF>, the report sequence at the end of the
determination is defined.
The entries are specific to the method and are stored in
the method memory.
report :
Definition of report blocks to be printed automatically at
the end of the determination.
The display texts of the Titrino are shown to the left.
The values are the default values.
>report
report COM1:
report COM1:full;curve
Report sequence for COM1 (input range depends on
the mode:
DET: full, short, mplist, curve, derive, comb, scalc full,
scalc srt, param, calc, calib, ff
MET, SET, MEAS:
full, short, mplist, curve, scalc full, scalc srt,
param, calc, calib, ff
CAL: full, short, scalc full, scalc srt, param, calc, calib,
ff
TIP: full, short, scalc full, scalc srt, param, calc, ff
Select a block. If you require more than one report
block, set a ";" as a delimiter between the blocks.
Identical for COM2.
Meaning of the report blocks :
full Full result report with raw results, calculations and statistics.
short Short result report with calculations and statistics.
mplist Measuring point list.
curve Titration curve (with DET and MET) or volume vs. time (with SET) or
measured value vs. time (with MEAS)
derive 1st derivative of the titration curve (with DET)
comb Combined titration curve and 1st derivative (with DET)
scalc full Full report of silo calculations.
scalc srt Short report of silo calculations.
param Parameter report.
calc Report with formulas and operands.
calib Calibration data.
ff Form feed on printer.
Original reports which are put out automatically at the end of the titration can be printed
with recalculated values at any time. Key sequence:
<PRINT><REPORTS><ENTER>.
DEF
(
2
def
>formula
>silo calculations
>common variables
>report
>mean
>temporary variables