Pocket Conductivity Tester
1
Thank you for selecting the METRIA pocket conductivity tester. This manual provides a step-by-step guide to help you operate the meter,
please carefully read the following instructions before use.
Installing the Batteries
•
Remove the battery compartment lid.
•
Insert the three G13A batteries into the battery compartment, note polarity.
•
Replace the battery compartment lid and turn clockwise until it is tight.
Keypad Information
INDEX:
KEY
FUNCTION
MEAS/HOLD
• Switches the tester ON/OFF.
• Locks the measured value,
press the key again to resume measuring.
•
In the calibration mode, confirms the setting value or exits the calibration.
CAL
•
Press and hold the key to enter the calibration mode.
•
Press the key again to increase the setting value.
°C
•
In the measurement mode, shows the current temperature.
•
In the calibration mode, decrease the setting value.