5
REV. 9/24/2020 INSTMPS-DPSL-BT
1.
Install the
MPS-DPSL-BT harness
and make all necessary connections but leave the
amp turn-on wire disconnected.
2.
With the arrow stamped onto the cap facing upwards, push the 16-pin connector from
the
MPS-DPSL-BT harness
harness into the left side of the cap. The locking clip on the
connector should face upward. Make sure the gasket is seating properly in the cap.
(Figure A)
3.
With the arrow stamped onto the cap still facing upwards, push the 20-pin connector
from the
MPS-DPSL-BT harness
into the right side of the cap. The locking clip on the
connector should face upward. Make sure the gasket is seating properly in the cap.
(Figure A)
4.
Plug the 16-pin and 20-pin connectors from the
MPS-DPSL-BT harness
into the
circuit board
. (Figure A)
5.
Slide the assembly into the case, then click it shut. Zip-tie the enclosure to a secure
location. Make sure the harnesses are pointing down to ensure that no outside
elements can enter the enclosure.
INSTALLATION
Cap (with O-ring)
Case
MPS-DSPL-BT
Circuit Board
AXDSP L
Harness
16-Pin
20-Pin
Gasket
Zip-tie Mounts
(Figure A)
