Metra Electronics 95-7801, Installation Instructions Manual

Page: 7 / 16

95-7801 DASH DISASSEMBLY
HONDA ACCORD 1998-2002
5
HONDA CIVIC 1999-2000
1
Disconnect the negative battery terminal to pre-
vent an accidental short circuit.
1 Disconnect the negative battery terminal to pre-
vent an accidental short circuit.
3
Cut and remove all mounting clips on the Radio
Housing EXCEPT clips "B" and "H". (Fig. B)
Skip to step #3a on Page 9.
3
Cut and remove the mounting tabs from the bot-
tom of the
Rear Support Tray (Fig. A). Cut and
remove the slots on the bottom of the ISO
Brackets (Fig. B). Locate tabs "A" on the ISO
Brackets for mounting, cut and remove tabs
"B" (Fig. C). Cut and remove all mounting clips
on the Radio Housing. (Fig. B)
Skip to step #3b on Page 10.
Remove (2) Phillips screws from the bottom
edge of the glove box door and remove the door.
Remove (3) Phillips screws from the lower steer-
ing column panel. Pull straight down on the
lower steering column panel and remove the
panel. Remove (2) Phillips screws under the cli-
mate controls. Remove (4) Phillips screws from
the lower dash location. Remove (4) Phillips
screws securing the bottom of the dash trim
bezel/head unit assembly and pull the assembly
out as far as possible. Cut the zip ties securing
the head unit and climate control wires, slide
dash trim bezel/head unit assembly from the the
dash cavity and disconnect the wiring. (Fig. A) 2
Unsnap the clock panel, disconnect the wiring
and remove. Remove (1) Phillips screw exposed
in the clock cavity. Remove (2) Phillips screws
below the factory head unit. Unclip the radio
trim bezel and disconnect the wiring. Remove
(4) Phillips screws securing the factory head
unit assembly and disconnect the wiring.
Remove (2) screws securing the factory pocket
to the assembly. (Fig. A) 2
A
"A"
Fig. B
Fig. C
Fig. A
B
A
"B"
"B"
"H"
"H"
B