Metra Electronics 95-7801, Installation Instructions Manual

Page: 6 / 16

95-7801 DASH DISASSEMBLY
HONDA ACCORD 1990-1993
4
1
Disconnect the negative battery terminal
to prevent an accidental short circuit.
Remove (4) screws from the lower portion
of the center console. Remove the gear
shifter knob and lift the console out.
Remove the ashtray and ashtray bracket.
Remove (2) screws from the bottom of the
head unit support, slide the unit out and
disconnect the wiring. (Fig. A) 2
HONDA ACCORD 1994-1997
1
Disconnect the negative battery terminal
to prevent an accidental short circuit.
3 Cut and remove all mounting clips on the
Radio Housing EXCEPT clips "A" and
"H" . (Fig. B) Skip to step #3b on Page 10.
3 Cut and remove all mounting clips on the
Radio Housing EXCEPT clips "C" and "H"
(Fig. A). Cut and remove the slots on the
bottom of the
ISO Brackets (Fig. B). (THE
REAR SUPPORT TRAY WILL NOT BE
USED).
(Fig. B) Skip to step #3b on Page 10.
Remove the ashtray and (1) 3/4" #8 Phillips
screw exposed. Open the storage compart-
ment and remove (2) #8 Phillips screws
exposed. Remove the cupholder tray and
(3) #8 Phillips screws inside. Lift the cen-
ter console out and remove (2) Phillips
screws exposed at the base of the dash
trim bezel. Unclip the bezel and remove.
Remove (2) hex-head screws securing the
factory head unit and disconnect the
wiring. (Fig. A) 2
A
"C"
"C"
Fig. A
Fig. B
"H"
"H"
B
A
"A"
"A"
"H"
"H"
B