Metos MONDIAL 300, Installation And Operation Manual, Page: 11 / 19

26.7.2004 Rev. 2.0
Operation instructions
5
4.3 After use
4.3.1 Cleaning
Switch (1:A) off the machine and remove the power supply plug from the socket.
Check that the slice thickness control (1:B) is on ”zero” position.
Carefully clean the machine immediately after use.
To clean the central part of the blade(1:L) and the blade cover (1:H) disassemble the blade
cover by unscrewing the blade cover knob (1:C).
To complete the cleaning operation of the product holder (1:D) proceed as follows: pull
the product holder support (1:P) at the beginning of the stroke; set the slice thickness con-
trol (1:B) to “zero”; unscrew the product holder support knob ((1:E); tilt the product-hold-
er (1:D). Once the cleaning operation is complete position the product holder (1:D) back
to its normal position and screw the knob (1:E) again.
Wipe the machine with a damp cloth.
Never clean the slicer with a detergent with a high pH value.
Never use sharp objects or a high-pressure spray gun for cleaning.
Never spray water on the machine.
4.3.2 Weekly maintenance
Remove the plug from the power supply socket and then check that the electric cable is in
good condition and is not cracked on the outside.
If the electric cable is cracked, get a specialist to attend to the machine before connecting
it back to the power supply.
Check that the sliding bar and the food-pusher bar have been lubricated as necessary. If
the product holder (1:D) and7or the food-pusher (1:G) don’t run freely, clean the relevant
bars carefully and lubricate with a few drops of machine oil.
Check that the blade (1:L) is in good condiyion and carry out sharpening process.
G Food pusher
H Blade cover
L Blade
M Separated blade sharpener
N Thumb guard
P Product holder support
Q Blade guard
R Food pusher handle
Machine Parts