17.3.2005
Rev. 2.0
Adjustment instructions
19
4. On the front pulley set the stud (E) on the varispeed collar (F) must be placed inside the
lower fork (G) and on the rear pulley set outside the fork for belt tightener (B), (both must
point backwards).
5. Tolerances in the transmission might cause that the special V-belt (A) is hitting the pins
of the pulley sets when the speed has been adjusted. In such cases the distance (X) must
be reduced.
6. Then follow the section: “Adjustment of speed”.
6.2
Adjustment of bowl centring
First find the present bowl centring: mount the beater and the bowl, then raise the bowl
arms up to normal working position. With your hand turn the beater and then measure the
distance between beater and bowl edge. By removing the rear covering the bowl arm
guide plate is now accessible (E) (Fig.4). Loosen the screws (D) and move the bowl arm
guide plate in required direction. Again turn the beater and measure the distance between
beater and bowl. When the bowl has been centred, fasten the bowl arm guide plate in the
new position and screw on the rear covering.
)LJ
