Meteor Communications Corporation MCC-545C, Operation And Maintenance, Page: 84 / 88

OPERATIONS 4-48
MCC-545C PACKET DATA RADIO
12/2000
MCC-545C COMMANDS
COMMAND DESCRIPTION PARAMETERS RANGE
†SUBST ,rrr,g1,nnn,g2 Substitute Remote unit information in data reports
received from a relay unit. rrr = relay ID
g1 = relay grp#
nnnn = Remote
ID
g2 = Remote grp# 1 – 245
0 – 15
256 – 4095
1 – 4
†SUBST,DEL,ALL
Delete entire substitution table
†SUBST,DEL ,rrr,g1 Delete entry in substitution table rrr = relay ID
g1 = relay grp#
1 – 245
0 – 15
†SWCTL,OFF
Disables the monitoring and switching function.
†SWCTL,ON, timeout , star
t delay
When the software boots up from a reset state, it will test
the two RS-232 ports to determine which one is currently
active, assuming the switch may have been manually
controlled while it was off. From then on, it monitors the
two Masters assuming the primary Master (1) is
connected to the DTA port, and the Secondary Master
(2) is connected to the ALT port. timeout =
inactivity time in
seconds resulting
in switchover.
start delay =
interval in
seconds after
starting before
monitoring
Master Stations. 1 – 32767
1 - 32767
SWCTL,SW, n Switch to designated Master Station switch position. n = switch
position
1 - 2
SWMON Monitors both the RS-232 port and RF link. This
SWMON command should be placed in the schedule of
the MCC-545C at an interval that detects a Master
Station failure within the required system design. There
are no parameters.
A typical example is: SCHED,I,5:0,SWMON