Meteor Communications Corporation MCC-545C, Operation And Maintenance, Page: 73 / 88

OPERATIONS 4-37
MCC-545C PACKET DATA RADIO
12/2000
MCC-545C COMMANDS
COMMAND DESCRIPTION PARAMETERS RANGE
†PASSWORDMODE ,acti
on, password
Used to enable/disable use of passwords. Default is
disabled. To enable or disable the operation with
passwords, enter this command giving the desired action
along with the current password for the unit. This will
trigger an automatic "save" operation. If set to the ON
mode, the state of the unit will be set to "logged-off". All
operator and remote commands except scheduled
commands,
$PENTM commands, and SDATA
commands will respond with "ACCESS DENIED!".
You will not be able to turn off the mode without first
logging on.
action =
ON – enable
OFF – disable
password = 3-20
character
password
A-Z, 0-9, -
$PENTM Without parameter string, display report of current Entek
MDP configuration.
† $PENTM,
ALERTEVENTS {,mask}
Set bit mask indicating Entek MDP status bits regarding
as alarms. Status bits are checked against this mask on
intercepted position reports and an alert message is sent
to the local MNT and DTA ports for each match. mask =
hexadecimal bit
mask
0 – FFFF
†$PENTM,ALERTMSG
S
{,nnn...}
Define canned messages constituting an alert. Any
number may be defined (up to 10 per line). Intercepted
messages matching one of these numbers cause an alert
message to be sent to the local MNT and DTA ports. nnn = canned
message number
1 – 120
$PENTM ,command string Send command string to local Entek MDP. command string =
any valid Entek
MDP command
string
†$PENTM ,action Enable/disable Entek MDP interface. When enabled,
allows communication with mobile data processor in
vehicle tracking applications and causes received status
bits from the MDP to be included with the position data
in the Remote's data reports. action =
ON – enable
OFF – disable