37
Mount flange and hex bolt. Lock the spindle by
prong spanner and tighten hex bolt counter-
clockwise with wrench firmly to fix blade.
Note: Only using attached wrench when mounting
or dismounting saw blade. When dismounting saw
blade, lift up safe cover. Loosen her bolt with
wrench and disassemble her bolt, flange and saw
blade.
GUARD
●
●
●
●
Release the safe cover block and lower the
handle, the guard will automatically rise. Finish
cutting and lift up handle, the guard will be back
to the original position.
●
●
●
●
Don
′
t damage or disassemble guard for your
safety.
●
●
●
●
Don
′
t use defective safe cover.
●
●
●
●
If transparent guard becomes so dirty that saw
blade or workpiece can
′
t be saw, disconnect the
plug from the power receptacle and clean guard
with damp cloth. Don
′
t use solvent or cleaner .
DUST COLLECTOR
●
●
●
●
Connecting dust collector, insert syphon into
the shred spout on the cover of saw blade and
put the inlet of dust collector on the syphon.
●
●
●
●
When the collector holds half bag of dust,
dismount it and unzip. Clean up the dust
collector.
Note: If using vacuum cleaner, operation will be
more effective.
SWITCH OPERATION
The switch is turned ON while the trigger is pulled
by finger. The power switch is turned OFF upon
releasing the trigger.
Note: Before plugging in, make sure whether switch
and trigger are normal.
ADJUSTMENT OF MITERED ANGLE
Loosen screws on guide plate. Turn the base to the
angle which needle indicates. Then tighten the
screws firmly to fix the rotative base.
Note: When turning the base, lift up the handle
ADJUSTMENT OF BEVEL CUT
Saw blade can incline 45°towards left.
When adjusting bevel cut, loosen the back lever
and incline the saw blade to the angle which
needle indicates. Then tighten lever to fix bracket.
wrench
Lock
Safe cover block
