6
RBM 1305-15 E | Version 1.02
Intended use
3
Intended use
The RBM 1305-15 E round bending machine is used ex-
clusively for the production of round shaped parts such
as pipes, cones, cylinders, etc. The material to be bent
must not exceed the maximum sheet thickness speci-
fied for the machine. The machine may only be operated
by a single person who has been instructed in the use
and maintenance of the machine.
Proper use also includes compliance with all information
in this manual. Any use beyond the intended use or oth-
erwise is considered misuse.
3.1 Unintended use
By observing the intended use, no reasonably foresee-
able misuse is possible, which could lead to dangerous
situations with personal injury.
3.2 Residual risks
Even if all safety instructions are observed, and the ma-
chine is put to its intended use, there are still residual
risks, which are listed below:
-There is a risk of injury to the upper limbs (e.g., hands,
fingers).
-Danger from falling workpieces
-Danger from the ingress of clothing and objects.
-During set-up and set-up work, it may be necessary to
dismantle on-site protective equipment. This creates
various residual risks and potential dangers that every
operator must be aware of.
4
Technical Data
4.1 Table
4.2 Type plate
Fig. 2: Type plate RBM 1305-15 E
WARNING!
Dangers in case of unintended use!
Misuse of the bending machine can lead to dange-
rous situations.
- Only operate the bender in the power range speci-
fied in the technical data.
- Never bypass or override the safety devices.
- Only operate the round bending machine in a tech-
nically perfect condition.
Technical Data
RBM 1305-15 E
Length
1650 mm
Width / Depth
1020 mm
Height
1110 mm
Weight
318 kg
Power of the drive engine
0,75 kW
Total power
2,5 A
Supply voltage
400 V
Bending bore min.
110 mm
Rolling speed
4 m/min
Working width max.
1270 mm
Diameter of the upper roller
75 mm
Bending capacity max. steel
400 N/mm²
1,5 mm
Conical bending perfor-
mance max. steel 400 N/mm²
0,8 mm
Bending capacity max. VA-
steel
1,1 mm
Conical bending perfor-
mance max. VA-steel
0,6 mm
Bending capacity max. alu-
minium
1,8 mm
Conical capacity max. Alu-
minium
0,9 mm
