21
1. INSTALLATION
FLUX 1
L ≥150 mm L1≥50 mm
FLUX 2
L ≥200 mm L1≥50 mm
1.1 PNEUMATIC CONNECTION
Pneumatic connection is via the threaded holes in the body.
• Install the device following the arrow indicating the direction of the air flow.
• To connect the inlet side, use a straight pipe
*
at least 150 mm-long for FLUX 1 and at least 200 mm-long for FLUX 2.
If straight piping is not installed, the accuracy may vary from what is stated.
*
Straight pipe
: the pipe must be straight with a constant cross-section.
• Clean the pipes before installation, uncleaned air may cause malfunctions or damages to the product.
• Make sure that the sealant does not get inside the pipe. Solid or liquid residues could damage the sensor.
When air flow needs to be regulated with a control valve; install the device upstream of the valve.
Otherwise, grease or lubricating oil from the valve could damage the sensor.
• The device can be installed in any direction.