ASSEMBLY INSTRUCTIONS FOR BOLT TOGETHER WORK TABLE
1) Assemble the four bolts, nuts and washers in table top/legs, as per diagram, wrench tighten.
2) Assemble the two bolts, nuts, and washers in table top/curved flat bar connection
piece, wrench tighten.
3) Assemble bolt, nut, and washer from curved flat bar connection to outer part of recessed top ring of
burner, wrench tighten.
4) Installation of casting directions are below. If casting has already been installed go to the Use and
Care section of this manual for further information.
Installation of Casting
14
6) Go to the Use and Care section of this manual for further information.
36825GAkk 3/29/06 9:49 AM Page 14
