KKDFF30T ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED:
ADJUSTABLE WRENCH
1. Place top half of unit on bottom half of unit as pictured.
2. Insert four long bolts through holes in top and bottom of unit.
Wrench tighten with supplied nuts.
3. Attach each wheel to the bottom half of the unit as pictured
using the supplied axels/nuts.
4. Attach the cylinder heat plate onto the crossbar as pictured
using two short bolts. Wrench tighten with supplied nuts.
5. Insert threaded ends of cylinder collar
into crossbar as pictured.
Wrench tighten with supplied nuts.
6. Attach the tank ring to the bottom half of
the unit as per diagram using the U clips
which are welded to the outside of the
frame.
7. Refer to Figure 4 above for hose
assembly instructions.
8. Go to the Use and Care Section of this
manual for further instructions.
11
Figure 4
DOUBLE HOSE WITH MALE FITTINGS AND NEEDLE VALVES WITH NON-
ADJUSTABLE PRESSURE REGULATOR.
Tighten the hose
fittings into the venturis
with a torque wrench,
up to a torque of 95 to
105 lb./in.
Alternatively, hand
tighten securely and
then, using a wrench,
tighten an additional
1-1 1/2 turns.
NOTE:
If your cooker has attachable legs or work table, or requires additional
construction, follow the assembly instructions for these before proceding to the Use and
Care Section.
4.
Go to the Use and Care Section for further instructions.
36825GAkk 3/29/06 9:49 AM Page 11
