Form 43343350
Oct 2013
-35-
15.0)
ELECTRICAL THERMOSTAT CONNECTIONS
Failure to do so may result in death or serious injury.
This appliance must be connected to a properly grounded electrical source.
Disconnect electrical power and gas supply before servicing.
ELECTRIC SHOCK HAZARD
1.
All electric wiring shall conform to the latest edition of the National Electrical Code (ANSI/NFPA No. 70), or
the code legally authorized in the locality where the installation is made.
2.
The unit must be electrically grounded in accordance with the National Electrical Code (ANSI/NFPA No.
70-latest edition). In Canada, refer to current standard C22.1 Canadian Electrical Code Part 1.
3.
The wiring providing power to the heater shall be connected to a permanently live electrical circuit, one that
is not controlled by a light switch.
4.
The power supply to the unit should be protected with a fused disconnect switch or circuit breaker. A service
switch, as required by local codes, shall be located in the vicinity of the heater (check local codes for
allowable distances) and should be identified as Heater Service Switch. All electrical wiring must be located
in accordance with the required Clearances to Combustibles from the heater as listed on the nameplate on
the heater.
5.
Connection to the power supply is provided by an 18/3 gauge x 72” long cord with grounded 3 prong plug.
6.
The post purge function of the burner (fan on for 30 seconds after the call for heat) will only be enabled
when using a 24 Volt thermostat. With the line Voltage thermostat post purge operation is disabled.
1-STAGE CONTROLS
Optional 24V thermostat connection
Jumper wire with 1/4 terminals pre-
installed. Remove the jumper and use
these two terminals for the 24V
thermostat connection if required.
72 grounded 3 prong
electrical cord
Liquid tight fitting
must be tight to
prevent ingress of
moisture in harsh
environments.
2-STAGE CONTROLS
24V 2 stage thermostat connection
Use these three terminals for the
24V thermostat connection.
72 grounded 3 prong
electrical cord
Liquid tight fitting
must be tight to
prevent ingress of
moisture
2-Stage Thermostat
43269060 rev A
HI
C
LO
