PAGE 1
ON/LIFT
OFF
ON GROUND
PROGRAM/CHANNEL
PRESET
PGM
/CH
EXIT
ENTR
COPY
0
PRESET
NUMBER
OUTPUT
RHY
LD1
LD2
SW
1 2 3 4
FX LOOP
DYNAMIC VOICE
PRESENCE
MASTER
LEAD 2 DRIVE
LEAD 1 DRIVE
BASS
MIDDLE
TREBLE
GAIN
PROGRAM/CHANNEL
PRESET
PGM
/CH
EXIT
0
1
2
3
4
5
6
7
8
9
5
6
7
8
9
10
4
3
2
1
0
A B
ENTR
ALL TUBE PREAMPLIFIER
OOGIE
B
M
ESA
COPY
PRESET
EXIT
ENTR
PROGRAM/ CH
4
FLASHES
OUTPUT
RHY
LD1
LD2
5
6
7
8
9
10
4
3
2
1
0
A B
LOOP
SW
SW
1 2 3 4
FX LOOP
ALL TUBE PREAMPLIFIER
OOGIE
B
M
ESA
TURN POWER ON AT REAR OF UNIT:
The AC Power Switch is a 3 position - center off type switch. Always try the ON/GROUND
position first (switch down). If hum is noticed in the sound, then try the ON/LIFT position. Whenever
possible it is best to use the grounded position for many reasons unless having
TriAxis
grounded
creates noise problems such as buzz or AC hum.
NOTE:
The A.C. power for
TriAxis
should be derived from the same power strip as that of the power
amp in use. Any effects units used should also be plugged into this same strip. This close proximity
of A.C. power supply for units within a system will prevent TONE degradation. Failure to follow this
wiring scheme may result in harsh or excessively bright tonal characteristics.
RUN THROUGH FACTORY PRESETS 1-10:
To do so use the left & right arrowed
Preset keys. (Notice that 11-20 do not sound
very different unless
TriAxis Switch 1 Jack is connected to a
MESA
Switch
Track power amp and Track Switching is used.)
NOTE :
Factory presets 1 thru 20 are Loaded automatically during power-up,
but can be disabled or reloaded manually by user when defeat procedure is
followed...see page 4 for directions.
TO INCREASE OR DECREASE:
Presets, Programs or Parameters use any of the arrowed keys.
TO ENTER AND SAVE NEW PARAMETER SETTINGS:
to an existing preset,
press the ENTR key two times. If pressed one
time Preset flashes to indicate it will be overwritten when you
press the ENTR key a second
time. If you happen to change your mind or wish to hear the original preset,
press the EXIT
key while PRESET is flashing to return to the original settings and void any changes you
had made.
TO ACTIVATE PROGRAMMABLE FX LOOP AND FUNCTION SWITCHES:
Press the LOOP SW key. This allows you to se-
quence through all the possible LOOP/SWITCH combinations.
Press
the key ENTR two times when the desired combination has been
selected to store this combination.