PAGE 23
CONTROLLER ASSIGN SUB - ROUTINE:
(Continued)
STEP 2:
Choose a Parameter. Press any left or right arrowed key under a parameter display and you will see the correspond-
ing display window begin to flash. For now (because you are most likely dealing with a new unit that has never been programmed) all
the parameters are set to Controller
00 (PROGRAM/CHANNEL window).
STEP 3:
Choose a Controller. Press the right arrowed key until the window displays the desired Controller number. Press the
PROGRAM left arrowed DECREMENT key if you go past the desired controller.
NOTE:
Remember, the flashing window displays the setting of the parameter
NOT the controller number. The Controller number
is displayed only in the “PROGRAM / CHANNEL” window. Don’t try to assign the controller to the flashing parameter window by
using the left & right arrowed keys below the parameter window...nothing will happen.
STEP 4:
Press the ENTR key one time. The parameter flashing will stop flashing momentarily and the “Controller” number ap-
pearing in the “PROGRAM WINDOW” will be assigned to this flashing parameter in that preset only.
STEP 5:
Repeat. Follow this same procedure for each parameter that you wish to modulate from Step 2 (do not press the SHIFT
key at this time.) After each parameter/controller assignment, press the ENTR key. Make sure the parameter window stops flash-
ing momentarily, indicating the assignment has been completed. With controllers assigned to all desired parameters, you are now
ready to move to the Value subroutine.
DYNAMIC VOICE
PRESENCE
MASTER
LEAD 2 DRIVE
LEAD 1 DRIVE
BASS
MIDDLE
TREBLE
GAIN
PROGRAM/CHANNEL
PRESET
PGM
/CH
COPY
0
1
2
3
4
5
6
7
8
00
PARAMETER KEYS
FLASH
9
BASS
MIDDLE
TREBLE
GAIN
PROGRAM/CHANNEL
PRESET
PGM
/CH
COPY
0
1
2
3
4
5
01
DOWN
UP
FLASH
BASS window display remains
flashing indicating you are
assigning a controller to this
parameter.
BASS
MIDDLE
TREBLE
GAIN
PROGRAM/CHANNEL
PRESET
PGM
/CH
COPY
0
1
2
3
4
5
01
PRESS ONCE ONLY
ENTR
FLASH
PAUSE IN
NOTICE THE MOMENTARY
PAUSE IN THE FLASHING
PARAMETER WINDOW.
IF YOU ARE NOT SURE
PRESS ENTER AGAIN.