20000403 – A – E6 Oven Operator Manual
9
SAVE THESE INSTRUCTIONS
UNPACKING OVEN
• Inspect oven for damage such as dents in door or inside oven cavity.
• Report any dents or breakage to source of purchase immediately. Do not attempt to use oven if damaged.
• Remove all materials from oven interior.
• If oven has been stored in extremely cold area, wait a few hours before connecting power.
RADIO INTERFERENCE
• Microwave operation may cause interference to radio, television, or similar oven. Reduce or eliminate interference
by doing the following:
-
Clean door and sealing surfaces of oven according to instructions in Cleaning Instructions section.
-
Place radio, television, etc. as far away from oven as possible.
-
Use a properly installed antenna on radio, television, etc. to obtain stronger signal reception.
OVEN PLACEMENT
• Do not install the oven next to or above a heat source such as a pizza oven or deep fat fryer. This could cause
microwave oven to operate improperly and could shorten life of electrical parts.
• Install oven on level countertop surface.
• If provided, place warning label in a conspicuous place close to microwave oven.
• Oven should be located so that plug is accessible when oven is in place.
• The switching operation of this microwave oven can cause voltage fluctuations on the supply line. The operation
of this oven under unfavorable voltage supply conditions can have adverse effects. This device is intended for
the connection to a power supply system with maximum permissible system impedance Zmax of 1.1 Ohm at the
interface point of the user’s supply. The user has to ensure that this device is connected only to a power supply
system, which fulfills the requirement above. If necessary, the user can ask the public power supply company for
the system impedance at the interface point.
IMPORTANT SAFETY INFORMATION
!
CAUTION:
!