MERRICK MC3 90.10.EX, Operation And Maintanance Manual

Page: 39 / 59

MC³ 90.10.EX O&M Manual - 32 -
Name Description
High Panel Meter Output Indicating that the Analog Input mapped to the Panel Meter
function has exceeded the limit switch value High Panel Meter. The
settings for this parameter is in the Limit Switches on page 24.
Low Panel Meter Output Indicating that the Analog Input mapped to the Panel Meter
function has dropped below the limit switch value Low Panel Meter.
The settings for this parameter is in the Limit Switches on page 24.
Ready All feeders associated with the current recipe are online AND
There are no fatal communication errors AND
All feeders are ready (The associated Ready output for each feeder is
enabled.) AND
The Feeder Block logical input is disabled AND
There are no FAULTS.
Running The control state of this controller is Running. Setpoint values and Run
Permission bit should be present at all slaves associated with the
selected recipe.
In Control The Ready (same as above) logical output is enabled AND
Run Permission logical input is enabled.
Good Feedrate All feeders associated with the current running recipe are feeding good.
(The associated output for
Feed Good is enabled in each running
feeder.) AND
The In Control logical output is enabled (same as above). AND
The feedrate is within the feedrate and deviation limits set in the Limit
Switch Menu.
AND
The recipe is running (the Running logical output is enabled). AND
There are no Warnings or Faults.
In Menu System Output indicating that the user interface is not in one of its main screens
In Calibration NOT USED
Register Access Used by the controller to permit the user to enter the low level register
editor.
Screen Locked NOT USED
Serial Setpoint The controller is using serial communications to derive the setpoint.
Analog Setpoint The setpoint method is set to Analog or Ratio.
COM1 Comm Lost Output indicating that Scalenet serial communication has been initiated,
and later timed out.
DF1 Comm Lost Output indicating that DF1 serial communication has timed out.
Power Fail Power was removed from the controller. This output only turns on when
the controller is initialized during a power up sequence.
Used Fdr Fault One of the slave controllers used by the selected recipe has a Fault
condition.
Free Fdr Fault One of the slave controllers not used by the selected recipe has a Fault
Condition.
Used Fdr Lost One of the slave controllers used by the selected recipe is no longer
communicating on the serial port or has been taken offline.
Free Fdr Lost One of the slave controllers not used by the selected recipe is no longer
communicating on the serial port or has been taken offline.
Used Fdr Warn One of the slave controllers used by the selected recipe has a Warning
condition.
Free Fdr Warn One of the slave controllers not used by the selected recipe has a
Warning Condition.