Merloni
Elettrodomestici
WASHING MACHINE AND WASHER-DRIER
Technical Fitting Manual
GB
99-11-03/01
9-14
Language
Issue/Edition
Page
5.2
Fitting the elements to the front of the machine
Fit the hinge supports to the surface, positioning the hole indicated by an
arrow in Fig. 5 towards the inside of the surface, and using screws of “type C”.
Fit the magnet striker on the opposite side at the top, using the two screws of
“type B”.
5.3
Using the drilling template
Bring the top edge of the drilling template up to the top edge of the panel,
ensure that it is correctly positioned and centred both vertically and
horizontally, referring to the lines drawn at the ends, and mark the positions
of the four holes on the wooden panel.
Using a milling cutter of suitable size, cut the four housings for the two
hinges, the rubber block and the magnet.
5.4
Fitting the elements on the wooden panel (door)
Insert the hinges into the housings prepared (the mobile part of the hinge
must be towards the outside of the panel) and fasten them using four screws
of “type A”.
Insert the magnet into the top housing on the opposite side from the hinges,
and fasten it using two screws of “type B”.
Insert the rubber block into the housing at the bottom.
The panel is now ready to be fitted on the machine.
5.5
Fitting the panel on the machine
Insert the prong of the hinge indicated by an arrow in Fig. 6 into the housing
on the hinge support, press the panel towards the surface of the machine and
fasten the two hinges using two screws of “type D”.
