Manual electrode welding operation
13
5.
Manual electrode welding operation
The welding units with the type MobiARC 280 cel can be used with only few settings and have
available a maximum for ease of use. These will be detailed in this chapter. The control panel
have available few and manageable controls for this reason it is easy to learn the controls
handling.
Establish the readiness for operation
•
Put the mains plug into the power outlet.
•
Plug the electrode cable and the ground cable.
Rutile infolded Stabelectroden (RR, RB, RC)
Electrode cable have to be plugged in the with „+“ marked socket,
ground cable have to be plugged in the with „-“ marked socket.
Basic infolded Stabelectroden (Bas, B, KB…)
Stabelectroden with cellulose coating (C, CEL)
Electrode cable have to be plugged in the with „-“ marked socket,
ground cable have to be plugged in the with „+“ marked socket.
•
Lock the bayonet lock. Fixate the pole terminal of the ground cable
at the workpiece. The contact point must be cleared of paintworks,
layers of fat and oxide layers.
•
Switch on the unit.
After starting the unit starts the run up phase. These begin with a lamp test (all lamps on the
control panel light up simultaneously short). Up next on display the information of the
software, the plant system as well as the machine settings as short text message.
5.1
To perform the Basic settings
The welding unit have available special attuned characteristic lines for different electrode types
thereof results ideal arc behaviour. This has the advantage that many other important Settings
are omitted, because characteristic lines present functions as for instance the functions of
current readjustment with short arc. Therefore, the welder has to carry out only few basic
settings.
