COPYRIGHT © 2005 MERIT INDUSTRIES, INC.
PM0519-03 MONEY SHOOT OWNER’S MANUAL
2
CPU Section
The CPU section is accessible by unlocking
the bottom door of the game. This section
houses an electronics box which contains
the motherboard, I/O board, power supply,
hard drive, and the main harness.
The Cash In, Cash Out, Hopper Refill, and
Prize Pool hard meters are attached to the
electronics box. See Figure 23. Each meter
is labeled.
Coin Mech/Bill Acceptor and Cash Box
The coin mech and/or bill acceptor are ac-
cessible by opening the monitor bezel of the
cabinet (see Figure 21). The coin box and
the hopper overflow bucket are located
within the metal cash box door. This door is
key-locked for security
.
Hopper
The hopper is located in the monitor bezel
compartment and dispenses coin prize
payouts. See the Hopper Setup section
of this manual for further instructions.
Security Keys
Money Shoot is equipped with two security
keys. Key 1 is located on the monitor con-
trol board. See Figures 1 and 22. Key 2 is
located on the I/O board and is permanently
installed in the game. See Figure 23.
Key 2 requires recharging after 40,000 Gen-
eral Purpose Plays (sum of all Amusement,
S.W.P. and Tournament credits) are used.
Once the number of General Purpose Plays
is less than 3,000, the message “Warning
X credits remaining, please recharge
key,”
will display in the SETUP Menu and
on the Refill screen.
To order Recharge Key kits (part number
KUV-113-002-01), contact your authorized
Merit Distributor.
If the number of General Purpose Plays de-
creases to 0 without being recharged, S.W.P.
mode will automatically deactivate and the
game will begin to use its 1,000 Emergency
Reserve credits. All Amusement and Tour-
nament games will continue to be available.
Once the 1,000 Emergency Reserve credits
are used, the game will limit play to 9 pre-
selected Amusement games. These games
cannot be changed by the operator. The
game will not regain normal functionality until
Key 2 is recharged.
General Care and Maintenance
NOTE: THIS GAME MUST ONLY BE SER-
VICED BY QUALIFIED SERVICE PER-
SONNEL.
CAUTION: THERE ARE HIGH VOLTAGE
PARTS IN THIS GAME. BE CAREFUL
WHEN SERVICING THE INSIDE OF THE
GAME. GAME SHOULD ALWAYS BE
UNPLUGGED BEFORE SERVICING.
Screen Calibration
•
Find the CALIBRATE button located on
the monitor control board and press it
to enter the screen calibration mode.
•
Touch the center of the first cross that
appears on the screen. Once you re-
lease your finger, a second cross will
appear.
NOTE: You must hold your finger on
the cross for approximately 2 seconds
for the calibration to be recognized.
•
Touch the center of the second cross
that appears on the screen.
•
Once the second cross is touched and
released, another cross will appear on
the screen. To test the calibration of
the screen, touch the cross with your
finger and slowly drag your finger
around the screen. The cross should
follow your movement.
•
Touch the EXIT button.
