COPYRIGHT © 2003 MERIT INDUSTRIES, INC.
FIGURE 21 - SYSTEM SETTINGS SCREEN
PM0378-07 MEGATOUCH COMBO JUKEBOX™ OWNER’S MANUAL 17
44. In the SOUND TEST box, touch TEST.
Listen to the test at all speaker posi-
tions to ensure everything is function-
ing properly. If you encounter a sound
problem, refer to the Troubleshooting
Guide.
Programming and Enabling the
Remote
45. To set the remote ID, press the JUKE
PAUSE and lower MIC VOLUME but-
tons on the remote at the same time
until the light on the LAMP button is
solid.
46. Press any combination of the P1, P2, or
P3 buttons three times to customize the
ID (for example: P2 – P1 – P3 or P3 – P1
– P1). The default setting is P1 – P1 –
P1).
47. Return to the Jukebox Operator menu
and touch the SYSTEM SETTINGS
button. The System Settings screen
appears. See Figure 21.
48. Touch LEARN, located next to Learn
remote control ID.
49. Watch the monitor. When prompted,
press any key on the remote control.
The monitor will return to the System
Settings Screen.
50. To allow the remote control to skip a
song that is playing (P3 button), set
Enable skip mode on remote to
ON.
51. Touch BACK to return to the Jukebox
Operator menu.
52. Enter the SOUND MIXER screen and
touch the TEST button to run the sound
test. As the unit is playing, raise and
lower the volume with the remote to
ensure it is working.
NOTE: If you change the remote ID, you
must have the jukebox relearn the ID
through the System Settings screen.
