COPYRIGHT © 2005 MERIT INDUSTRIES, INC.
ATTENTION:
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES
Removal/Installation of Major Assemblies -
MAXX Upright
Troubleshooting Information - Removal/Installation of Major Assemblies -
MAXX Upright
Megatouch MAXX Technical Reference Manual
SCREW AND
WASHER
FASTENING
HARD DRIVE
MOUNTING
PLATE TO
CPU TRAY
SCREWS AND
SHOULDER
WASHERS
FASTENING
HARD DRIVE
TO MOUNTING
PLATE
(4 PLACES)
GROMMET
POWER
CONNECTOR
HARD DRIVE
RIBBON
CABLE
FIGURE 1 - MAXX UPRIGHT - CLOSEUP OF HARD DRIVE
5. Use dental floss to carefully cut the foam tape holding the touchscreen to the picture tube until
you are able to completely remove the touchscreen.
6. Remove any remaining adhesive residue with denatured alcohol, then wipe the surface of the
picture tube with the supplied alcohol wipe.
Touchscreen Installation
1. Clean the reverse side of the replacement touchscreen with the supplied alcohol wipe.
2. Peel the backing from the 8 pieces of double-sided foam tape already adhered to the reverse
side of the touchscreen.
3. Replace the new touchscreen over the picture tube (with the cable on the right if you are facing
the game), making sure the screen is properly and evenly aligned over the picture tube. Then
clean the front of the screen with the supplied alcohol wipe.
4. Connect the new touchscreen cable in the back of the controller and secure the controller on
the mounting screws in the game with the existing hardware (see Figure 3). Also connect the
Molex connector (orange and gray wires) to the main power harness.
5. Remembering the manner in which the tape was placed around the touchscreen you removed,
place and cut a length of the supplied black poly tape evenly over an entire edge of the touch-
screen and repeat until all 4 edges are covered.
6. Place and cut a longer length of black poly tape around all 4 edges of the screen.
7. Plug in and turn on the game.
8. When the game is finshed booting, calibrate the touchscreen.
9. Close and lock the front bezel.
