Meridian HARVEST T1062, Operator'S Manual

Page: 13 / 39

4.2 Auger Drive & Lockout _
The proper operation of this auger requires that the operator pre-inspect
the drive system, know how to shut down the system in an emergency,
and generally monitor the system during operation.
Drive System and PTO Driveline: Ensure that the PTO drive on the
tractor is in the o ff position before starting the tractor. Stay clear of PTO
hazard area. Do not exceed the maximum operation length of 80 inches
of PTO driveline, or the maximum angularity of 30 degrees.
Lockout/Shutdown of PTO Driveline: Turn o ff engine. Remove ignition
key from tractor. If for some reason, you cannot remove the key, remove
the PTO driveline from the tractor.
4.3 Start Up & Break In _
DANGER:
Electrocution Hazard! Make sure that all unauthorized personnel are
clear from the operation zone. This auger is not insulated. Be alert
to overhead obstructions and electrical wires. Electrocution can
occur without direct contact. Do not raise or lower auger until
hazardous area is cleared. Failure to maintain proper clearance can
result in serious injury or death.
Have you completed the pre-operational checklist? If everything is
satisfactory, prepare for a 30 minute operation at half speed to break in
your auger. Double check that the intake hopper is properly positioned,
and the PTO drive on the tractor is in the o
ff position.
NOTICE:
When starting the auger for the first time, be prepared for an
emergency shutdown in case of excessive vibration or noise. The
auger may run roughly until the tube is polished.
Start the tractor and idle at low RPM. Slowly engage the PTO driveline.
Gradually begin to feed grain into the intake hopper, bringing the speed
of the PTO to 200 RPM. Do not over-feed the hopper on initial loads;
keep the feed of the grain at half capacity. After the auger tube is
13