Meridian HARVEST T1062, Operator'S Manual

Page: 19 / 39

6. Maintenance & Storage
Proper maintenance of auger will result in both a longer life of the auger
and a safe and e
ffi cient operation.
6.1 General Maintenance _
Always replace damaged or worn parts before using the auger. Use only
replacement parts manufactured by Harvest
by Meridian
. Use of
unauthorized parts will void the warranty of your auger. Contact your
Harvest
by Meridian
dealer to order parts.
Harvest
by Meridian
augers are designed and tested for a safe, e ffi cient
operation. Do not modify the equipment in any way. Modification to the
auger can create an unsafe working condition, a
ff ect the life of the
equipment, and will void your warranty.
Before performing maintenance on your auger, shut down and lock out all
power. Disconnect the PTO driveline from the tractor. Support the auger
tube before attempting maintenance on the undercarriage. The auger
should be in full down position before attempting maintenance.
After Maintenance is completed, replace and secure all safety shields,
safety devices, service doors and cleanout covers.
See section 5, “Hydraulics” for information on maintenance of hydraulic
hoses.
See section 7, “Appendix & Forms” for expanded lube information.
Winch: Keep a film of grease on the gears. Occasionally oil the bushings,
drum shaft, and ratchet. Do not get oil or grease on the brake discs.
Replace the brake discs if they wear down to less than 1/16” thick.
Lift/Truss Cables: Replace cables if frayed or damaged. Be sure clamps
are secure. Adjust cables as needed to keep the auger tube reasonably
straight.
Wheel Hubs: Repack hubs every two to three years to lengthen the life of
the hubs.
19