Meridian HARVEST H10 Series, Operator'S Manual

Page: 12 / 53

not exceed the maximum operation length of 34 inches of PTO driveline, or the
maximum angularity of 30 degrees.
Lockout/Shutdown of PTO Driveline: Turn o ff engine. Remove ignition key
from tractor. If for some reason, you cannot remove the key, remove the PTO
driveline from the tractor.
4.3 Start Up & Break In _
DANGER:
Electrocution Hazard! Make sure that all unauthorized personnel are
clear from the operation zone. This auger is not insulated. Be alert to
overhead obstructions and electrical wires. Electrocution can occur
without direct contact. Do not raise or lower auger until hazardous area
is cleared. Failure to maintain proper clearance can result in serious
injury or death.
Have you completed the pre-operational checklist? If everything is satisfactory,
prepare for a 30 minute operation at half speed to break in your auger. Double
check that the intake hopper is properly positioned, and the PTO drive on the
tractor is in the o
ff position.
NOTICE:
When starting the auger for the first time, be prepared for an emergency
shutdown in case of excessive vibration or noise. The auger may run
roughly until the tube is polished.
Start the tractor and idle at low RPM. Slowly engage the PTO driveline.
Gradually begin to feed grain into the intake hopper, bringing the speed of the
PTO to 200 RPM. Do not over-feed the hopper on initial loads; keep the feed of
the grain at half capacity. After the auger tube is polished and runs smoothly,
proceed to unload at full speed (at but not to exceed 540 RPM for maximum
e
ffi ciency).
Upon completion of initial run, slow down until the auger is empty of grain, and
stop auger. Lock out the power source and conduct a complete inspection of
the auger, following the pre-operation checklist. After the initial start up and
inspection, the auger should be shut down and inspected at least three times
during the first hours of operation. Once your auger is broken in, the pre-
operation checklist should be part of the daily routine before you operate the
auger.
11