Meridian HARVEST H10 Series, Operator'S Manual

Page: 18 / 53

Lube Recommendation: Lube cross and bearing every 8 hours of use. Lube
telescoping members yearly.
NOTICE:
Replacement parts are not lubricated. When you receive these parts in,
make sure to lubricate and tighten screws.
Mechanical Chain Drive: Keep drive chain tension adjusted to about ¼ ”
deflection by loosening the four bolts on the lower bearing, then retightening.
Oil the chain frequently enough to keep a film of oil on the chain. This must be
done through the maintenance portal. Replace shield after maintenance.
Universal Joint: Remove PTO guard cover and lubricate grease fitting in the U-
Joint every eight hours of use. Check PTO retain bolt and retighten if necessary.
6.2 Storage of Auger _
Make sure that auger is in the full down position. Remove all residual material
from the hopper and auger tubes. Touch up all scratches on the auger to
prevent rusting.
Clean and re-lubricate spline on the PTO driveline. Cover with plastic bag to
protect from weather, and place it in the transport latch.
Move auger to your storage area, park, and chock wheels.
Before using the auger after storage, replace any damaged parts or decals,
remove plastic bag from PTO driveline and re-lubricate, and conduct general
maintenance procedure.
17