Meridian HARVEST H10 Series, Operator'S Manual

Page: 14 / 53

If auger is full of grain, do not restart at full speed. Engage PTO at low RPM and
gradually increase power until normal operating speed is achieved.
CAUTION:
Starting the auger under load may result in damage to the auger. Make
sure there is no blockage.
4.6 Completion and Cleanup _
At completion of operation, the auger needs to be moved into storage position.
Make sure that the entire work area is clean, remove all supports and wheel
chocks, move auger out of working position, and fully lower the auger (see
lowering procedure below).
The proper steps for clean out of the auger are as follows:
1) Disengage power source; lower the auger into transport position.
2) Shut o
ff tractor and lock out power.
3) Move intake hopper into transport position and latch with safety chain.
4) If necessary, clean out grain using small shovel or other tool.
WARNING:
Do not leave auger in raised position when not in use. Auger could drop
rapidly in case of hydraulic failure. High winds may also upset the
auger. Because the hydraulic scissor lift is faster than a hand crank
system, use extra caution and clear area of personnel before raising or
lowering auger.
4.7 Lowering the Auger _
Check that auger and hose couplers are securely attached to your tractor.
You may need to raise the auger discharge end up and out of bin or storage
facility before proceeding.
Remove wheel chocks, and check that the area around and under the auger is
clear of debris and unauthorized personnel. Wheels must be free to move when
raising or lowering the auger.
Slowly pull away from bin or storage facility. As soon as you are clear, engage
the hydraulics and lower the auger. Once valves are open, the auger lowers by
13