C o n f i g u r i n g
t h e D V D p l a y e r
Speakers
To configure speakers
If you are using the G92 in a surround application, directly
connected to up to six DSP loudspeakers, or power amplifiers
and analogue loudspeakers, the
Speakers
menu allows you to
configure the speaker layout and enter calibration settings.
• Highlight
Speakers…
in the
Audio setup
menu, and press
Enter
.
The
Speakers
menu will be displayed:
The options are summarised in the following table:
To calibrate the speaker layout
• Highlight
Calibration…
in the
Speakers
menu, and press
Enter
.
The
Calibration
menu will be displayed:
• Highlight
Distance units
and press
Enter
to change the
distance units between cm and inches.
Then for each speaker adjust the
Gain
and
Distance
as follows:
• Press
V
to highlight the
Gain
figure and press
Enter
to edit it.
You will hear a noise test signal from the corresponding channel.
Option
Values
Description
Left/Right
L DSP, S DSP, L An, S An
Whether the main left and right loudspeakers should handle the bass (Large),
and their type.
Centre
Off, L DSP, S DSP, L An, S An
Whether there is a centre loudspeaker, and its bass handling and type.
Subwoofer
Off, Dig, An
Whether there is a subwoofer, and its type.
Surround
Off, L DSP, S DSP, L An, S An
Whether there are rear surround speakers, and their bass handling and type.
Calibration…
See above.
