Configuring the 808
Anniversary System
CD Player
Setting up sources
This section explains how to use Gain mode to set up
the analogue sources connected to the 808.
To turn on Gain mode
Put the 808 into standby by pressing
Off
(front panel
or remote).
Press and hold the
Volume
V
key under the front
panel for at least five
seconds.
The display shows:
Gain On
The 808 will then return to standby with Gain mode
turned on.
Gain mode adds an extra
Sensitivity
option to the
menus.
To turn off Gain mode
Repeat the above procedure.
The display shows:
Gain Off
To adjust the sensitivity of a source
To obtain the best signal-to-noise ratio for your
analogue sources you can adjust the sensitivity of each
input to give the highest level that does not produce
clipping.
Turn on Gain mode, as described above.
Select the source you want to adjust, with loud
source material playing.
Press
<
or
>
(remote) until the display shows the
current sensitivity.
For example:
Radio 2.0V In
Press
A
or
V
(remote) to change the sensitivity.
•
•
•
•
•
•
•
You can select between sensitivities of 0.V (most
sensitive), 1.0V, .0V, or .V (least sensitive).
If the sensitivity is set too high the input will clip the
loudest passages. The display shows:
For example:
Radio 0.5V In Clip
In this case reduce the sensitivity.
If you have selected a digital source you cannot adjust
the sensitivity. The display shows:
For example:
CD Not Analogue
Summary of Contents for DSP8000
