8
Configuring
the DSP8000
loudspeakers
Configuring the setup options
The setup options allow you to adjust the frequency
response of the loudspeakers to compensate for
their position. You only need to configure the master
loudspeaker.
When configuring the DSP8000 loudspeakers,
point the remote at the speakers, even if you have a
Meridian Surround Controller.
To select Setup mode
Turn off the DSP loudspeaker using the power switch
on the back panel.
Turn on the power again while holding down the
Store
key on the remote.
The display will show:
Setup
It will then revert to standby:
The display shows:
.
You can now operate the speaker in the usual way,
using the additional setup menus to adjust the
response while listening to sources.
When you have finished adjusting the setup options:
Switch off at the back panel, and then switch on
again to restore normal operation with the setup you
have programmed.
•
•
•
To adjust the frequency response
Press
Function
>
or
Function
<
until the display
shows the current response setting.
For example:
Free
Press
Function
A
or
Function
V
to select the
appropriate option as follows:
Option
What it means
Free
Flat frequency
response.
Boundary
Speaker closer than
0.m (0") to a wall.
Sub.1
Applies a second-order
high-pass filter at
80Hz for use with an
analogue subwoofer.
Sub.2
Applies a second-order
high-pass filter at
10Hz for use with an
analogue subwoofer
Corner
Speaker closer than
0.m (0") to a corner.
•
•
Summary of Contents for DSP8000
