Appendix
51
D6000 User Guide
Type 5 setup, Meridian 500 system not using 562
The CD is connected directly to D1, all other sources are routed directly or
via an A/D converter to D2. Type 5 sets the D6000 as a left master, so
you will need to make the other a right slave, or adjust left/right on both
speakers.
Type 5
500
500, 506, 508
Remote key
Logo
Input on
D6000
Control?
Address
CD
cd
D1
1C
1A
Radio
rd
D2
2C
1A
LP
LP
D2
NC
1A
Video
tn
D2
NC
1A
Tape 1
t1
D2
NC
1A
Tape 2
t2
D2
NC
1A
CDR
Cr
D2
NC
1A
Cable
Cb
D2
NC
1A
Text
tt
D2
NC
1A
VCR1
U1
D2
NC
1A
VCR2
U2
D2
NC
1A
LaserDisc
Ld
D2
NC
1A
Appendix 2 Test mode
Test mode is not recommended for everyday use. As its name suggests,
however, it is very useful for testing the installation and the speakers.
The main advantages of Test mode are that you can directly display
which of the D6000's physical inputs has been selected, and that entering
or leaving this mode does not change any of the programming you may
have done previously.
1. Switch on the power supply to the master speaker only while
continuously pressing the Next key on the MSR. The speaker will
display
1L
65
and the red light will be on.
2. Switch the power off. You have now set the test master.
3. Switch on the power supply to the slave speaker only while
continuously pressing the Previous key on the MSR
1L
65
4. Switch the power off. You have now set the test slave.
If you now turn both speakers on, they will come up in Test mode.
To get back to normal user mode:
1. Switch on the power to each speaker with the Clear key pressed
