Customising using Config
30
D6000 User Guide
Customising using Type
Type is a mode used specifically to restore the entire memory (except the
calibration memory) of D6000 to one of three factory-preset
configurations. For all three Types, Type resets the following:
•
phase to positive
•
axis to –1
•
balance to central (L 0)
•
tilt to 0.0
•
bass to 0.0
•
loudness to normal
•
speaker to left master
Depending on the Type selected, the other options are set as follows.
More information is given in Appendix 1, on page 48.
Type
Application
D1 input
for
source
D2 input
for
source
1
500 mode, controller like 562
all
na
2
208 mode, with other Meridian
equipment in the system
CD
others
3
201/601 mode, with other Meridian
equipment in the system
all
na
4
201/601 mode, with other Meridian
equipment in the system
CD
others
5
500 mode, CD direct
CD
others
When programming D6000 speakers, it is best to choose one of the three
standard Types as a starting point, and it may be possible to find one that
meets your needs exactly. Otherwise, choose the one that is closest to
your requirements. Select it, and set up the master/slave and left/right
speakers, by means of the following steps:
Selecting Types
1. Switch off the D6000, using the power switch on the back, and wait for
3 seconds
2. While pressing the 1 key (2 for Type 2, 5 for Type 5) on the remote
control, switch the power on again. The display will read
TY.
#
where # is the Type you have selected.
3. Release the # key
After a couple of seconds, the display will change to
L.
This indicates that this speaker will be a left master.
Choosing left or right
To change the speaker from left to right, or vice versa:
1. Press the menu
n
n
or
s
s
on the remote control
Choosing master or slave
To change a master to a slave, or back again:
