Merida M30A, Installation And Operating Manual

Page: 4 / 68

4
During this process of fitting the casing to the base take care not to damage the electronic
circuit that is below the hand dryer’s nozzle (Figure 11).
It is also very important to ensure that once mounted and screwed to the base the casing
has the plastic protector correctly placed on the lower inverted “U” shaped window (Figure
12).
NOTE: contemplate a minimum distance of 400 mm (15,80”) away from ledges, marble tops or
wash basins (Figure 13). Avoid as much as possible the presence of reflecting surfaces
within the area of the hand dryer’s IR sensor.
Adjust the speed of the motor and the detection distance.
The hand dryer has means to adjust manually the distance for detecting hands and the speed of the
drying air.
These adjustments of the motor speed and detection distance must be made by a qualified
technician only.
The adjustments can be made by moving the respective cursors of the two linear potentiometers, as
shown in figure 14.
Figure 11.
Figure 12.
Figure 13.
Figure 14.
GB
Figure 14.