Merida M30A, Installation And Operating Manual

Page: 2 / 68

2
‘Machflow’ range hand dryers offer the following technical features:
Automatic operation. Hand detection is based on IR-type movement sensors.
They are class I devices, with earthing.
They provide a potent beam of air, intense and even.
The distance for detecting hands is adjustable.
The speed of the air generated by the hand dryer can also be adjusted, to achieve an
optimum balance between the drying power and noise level.
The hand dryers inclu de an intelligent detection system which eliminates static ‘targets’
(marble, shelves or similar). After detecting a static target, the dryer will disconnect a few
seconds later.
It includes a vandal-proof system with an automatic stop. Maximum continuous functioning
time is 60 seconds.
It includes a universal high speed motor that is activated gradually to control the inertia of its
ignition torque and thus ensure a longer useful life of the hand dryer.
ONLY A QUALIFIED TECHNICIAN CAN INSTALL, ADJUST AND MAINTAIN THIS HAND
DRYER.
Removal of the casing.
The hand dryer is supplied with the casing fitted to the base without tightening (Figure 1).
Carefully remove the casing since it is connected to the base by a tab that joins the two
pieces (casing and base) at the rear (Figure 2).
Remove the casing keeping it at an angle at all times (Figure 3) until the upper tab is
completely withdrawn, taking care to:
ü
not damage the internal components, in particular the electronic circuit,
ü
not scratch or damage the LED sensor screen,
ü
not damage the surface of the casing.
ATTENTION: WHEN THE CASING IS DISMANTLED ACTIVE PARTS OF THE DEVICE BECOME
ACCESSIBLE.
INTRODUCTION
GB
INSTALLATION
Figure 1. Figure 2. Figure 3.