Storage Preparation
The major consideration in preparing your outboard for storage is to protect it
from rust, corrosion, and damage caused by freezing of trapped water.
The following storage procedures should be followed to prepare your outboard
for out of season storage or prolonged storage (90 days or longer).
NOTICE
Without sufficient cooling water, the engine, the water pump, and other
components will overheat and suffer damage. Provide a sufficient supply of
water to the water inlets during operation.
FUEL SYSTEM
IMPORTANT: Gasoline containing alcohol (ethanol or methanol) can cause a
formation of acid during storage and can damage the fuel system. If the
gasoline being used contains alcohol, it is advisable to drain as much of the
remaining gasoline as possible from the fuel tank, remote fuel line, and engine
fuel system.
IMPORTANT: This outboard is equipped with a closed fuel system. Fuel within
the engine's fuel system, other than the fuel tank, will remain stable during
normal storage periods without the addition of fuel treatment stabilizers.
Fill the fuel tank and engine fuel system with treated (stabilized) fuel to help
prevent formation of varnish and gum. Proceed with the following instructions.
•
Permanently installed fuel tank ‑ Pour the required amount of Quickstor
Fuel Stabilizer (follow instructions on container) into a separate container
and mix with approximately one liter (one quart) of gasoline. Pour this
mixture into fuel tank.
Description
Where Used
Part No.
Quickstor Fuel Stabilizer
Fuel tank
92-8M0047932
Protecting External Outboard Components
•
Touch up any paint nicks. See your dealer for touch‑up paint.
•
Spray Quicksilver or Mercury Precision Lubricants Corrosion Guard on
external metal surfaces (except corrosion control anodes).
Description
Where Used
Part No.
Corrosion Guard
External metal surfaces
92-802878 55
Protecting Internal Engine Components
Contact an authorized Mercury Marine dealer to execute the following:
IMPORTANT: Refer to the appropriate service manual for spark plug
inspection, removal, and replacement procedures.
•
Remove the high tension spark plug leads and spark plugs.
STORAGE
eng
117