Oil Filter Wrench
91‑889277
5221
Aids in the removal of the oil filter.
3. Clean the remaining oil from the filter mounting base area.
4. Apply a film of clean oil to the filter gasket.
IMPORTANT: Do not use grease on the filter gasket.
5. Install the new filter until the gasket contacts the base and then tighten 3/4
to 1 turn.
OIL FILLING
Remove the oil fill cap and add approximately 13.3 liter (14.0 US qt) of the
recommended oil. This will bring the oil level within the operating range.
a -
Oil fill cap
b -
Dipstick
NOTE: It is not necessary to check the oil level immediately after changing the
oil. The engine must be run for a while and then turned off for one hour or
longer before checking the oil level. Refer to
Checking Engine Oil Level.
Checking Engine Oil Level
After the engine oil has been changed, the engine should be run for a few
minutes and then turned off, allowing one hour or longer before checking the oil
level.
IMPORTANT: For an accurate oil level reading, the engine must be vertical for
several minutes before removing the dipstick.
1. Remove the dipstick, wipe it clean, and install it fully into the dipstick tube.
71992
a
b
MAINTENANCE
eng
97