FEATURES AND CONTROLS
64
eng
The helm transfer function allows the boat operator to select
which helm is in control of engine operation. Pressing the throttle
only/station select button two times allows engine control to be
transferred to a new helm. When a helm transfer is initiated, the
control will automatically start adjusting engine RPM and gear
position to match the control handle setting at the new helm.
Adjust the control handles to the desired throttle and gear
position.
NOTE: There is a 10 second time frame to complete a helm
transfer. If the helm transfer is not completed, the action will be
cancelled and a double beep will sound. Pressing the throttle
only/station select button again will reinitiate a helm transfer.
1. Place the active remote control lever to idle position.
2. Proceed to the inactive helm and position remote control
lever to the idle position.
3. Press throttle only/station select button two times. The
"ACTIVE" light will illuminate to indicate the remote control is
in control of the engine.
a -
Active light
b -
Throttle only/station select button
4. The "ACTIVE" light will switch off at the original helm.
Synchronizing Helms Prior to Helm Transfer
Pressing the throttle only/station select button one time allows
the boat operator 10 seconds to match up the control handle
setting at the new station with the handle setting that is at the old
(to be inactive) station. If the handle is not matched, the neutral
light will flash. The light blinks faster as the handle is nearing
match position. Once the light stays on continuously, the handle
is matched and the throttle only/station select button can be
pressed again to complete the transfer. This completes the
transfer process, and gives control to the new station. If the helm
transfer is not completed within 10 seconds, the helm transfer is
cancelled.
START
STOP
22608
a
b
Summary of Contents for 200 OptiMax DTS
Page 6: ...vi eng ...
Page 12: ...xii eng ...
