Mercury 2.8 EI 200, Manual

Page: 39 / 118

ON THE WATER
SECTION 3
CMD-4081877 / 90-865861040 MARCH 2004 Page 31
CE526
STARTING A WARM ENGINE
1. Place control handle in NEUTRAL.
2. Turn key switch to the RUN position.
3. Turn key switch to START position and release when engine starts. Ensure charge
indicator and oil pressure warning lamps go off.
4. Check to ensure all instrumentation is functioning properly and indicating normal
readings
CE483
SHIFTING
CAUTION
Never attempt to shift the transmission unless the engine is at IDLE rpm. Damage
to the transmission could occur.
1. To shift unit, ensure remote control/throttle lever is in NEUTRAL. Move control/shift lever
forward to shift to FORWARD gear, or backward to shift to REVERSE. After shifting the
transmission, advance the throttle to the desired setting.
2. Once underway, engine oil pressure should be within the range listed in the engine
specifications chart at maximum rpm, or wide-open-throttle. Stop the engine if oil
pressure is not within this range. Locate and correct the problem, or see your authorized
Cummins MerCruiser Diesel dealer / distributor if you are unable to determine the
problem.
CD366
ENGINE SHUT-DOWN (STOPPING)
1. Place remote control lever in NEUTRAL.
CAUTION
Avoid damaging the turbocharger and engine. Immediate engine shutdown
(stopping) after high load operation may result in permanent turbocharger bearing
damage. Operate the engine at IDLE for several minutes before shut-down.
2. Operate the engine at idle speed for several minutes to allow the turbocharger and
engine to cool.
3. Turn key switch to the OFF position.