Boleslavova 4, 709 00 Ostrava 9
tel / fax: +420 59 662 70 97
Created: 14.8.2019 , version 1.100en
- 4 -
email: [email protected]
Decimal point mode
The numeral flashes together with the decimal point. To change the position of the decimal point,
press the button and change it one position to the right with each press.
00000
0
.
00
0
.
000
000
0
.
00
0000
0
.
0
hotovo
Address menu of DMP 11
The individual functions and settings of the device are accessible at so-called addresses for simplicity.
After entering the correct password, we enter the address menu, each address has its own number
and is displayed in the format
A_00
,
A_01
,
A_02
etc. To move up in address menu, press
the
key and to move down the
key. To enter the selected address, press the
key. To exit the
address and return to the address menu without changing the data, press the key.
If we change the numeric value or option at the given address, we are informed about the successful
writing to the EEPROM by a message
hotovo
. We confirm this message with the
key and the
device returns to the address menu to the given address. To exit the address menu and return to the
main view, press the key.
After entering the menu, the device continues to measure at 4 measurements / sec. The
device returns to the main display for longer periods of inactivity. When you exit the menu, the
device remembers the password
for 1 minute
, so you do not need to enter it when you re-
enter menu. You delete the password immediately from the temporary memory of the device by
key
. When entering the menu again, the last selected address is displayed.
The number of available addresses in the address menu depends on the device configuration
and its equipment.
If the password is forgotten, the password can be temporarily reset to factory‘s default.
Turn off the device and turn on the device again with the keys
and
pressed. The
password is now set to 1432 for 10 minutes and the original password can be viewed in
the menu or a new password can be set.
Warning messages
E Advc
Device malfunction, contact manufacturer
E -Inp
Input signal is lower than 3,8 mA
E PASS
Invalid password was entered
E Inp
Input signal is higher than 20,5 mA
hotovo
Data were stored into EEPROM
Ovt-rA
Displayed value is lower than -65535
E Lin
L1 value out of preseted range
Ovt ra
Displayed value is higher than +65536
E dAta
EEPROM data integrity error, contact the manufacturer for further instructions
Device keys description
key
Main display mode function
Address menu function
Function in address
Switching displayed items
Move up in addresses
Numeric input change or
numeral digit on position change
Move down in addresses
A selected digit shift to the right
Enter selected item
Enter in to selected address
Confirmation and saving into EEPROM
Return to measured value display
Return to main display mode
Escaping withou
saving
!
