14
OUt
Output Menu
CtrL
Control Mode
1SP
Single set point.
2SP
Two fully independent set points.
SPAL
Single set point and alarm.
1SP
SP1
, Set Point 1, Reverse or Direct Acting
DIR
Direct. Relay turns on with increasing pressure.
REV
Reverse. Relay turns on with decreasing pressure.
DEL1
SP1
, Set Point 1, Time Delay
Sets the amount of time a set point condition must be continuously met before the set point condition
is recognized. The
DEL1
delay is adjustable from 0-60 seconds.
LEd1
SP1
, Set Point 1, Lamp
OFF
The
SP1
LED on the front panel turns OFF when the
SP1
relay turns OFF.
The
SP1
LED on the front panel turns ON when the
SP1
relay turns ON.
ON
The
SP1
LED on the front panel turns ON when the
SP1
relay turns OFF.
The
SP1
LED on the front panel turns OFF when the
SP1
relay turns ON.
The following
SP2
function values are only activated when
CtrL
is set to
2SP
:
2SP
SP2
, Set Point 2, Reverse or Direct Acting
DIR
Direct. Relay turns on with increasing pressure.
REV
Reverse. Relay turns on with decreasing pressure.
DEL2
SP2
, Set Point 2, time delay
Sets the amount of time a set point condition must be continuously met before the set point
condition is recognized. The
DEL2
delay is adjustable from 0-60 seconds.
LEd2
SP2
, Set Point 2, Lamp
OFF
The
SP2
LED on the front panel turns OFF when the
SP2
relay turns OFF.
The
SP2
LED on the front panel turns ON when the
SP2
relay turns ON.
ON
The
SP2
LED on the front panel turns ON when the
SP2
relay turns OFF.
The
SP2
LED on the front panel turns OFF when the
SP2
relay turns ON.
LdL9
Relay Alternation (See page 8)
OFF
There is no alternating function.
ON
Relays will alternate with set points
SP1H/L
and
SP2H/L
with every cycle of set
points.
2SP
control mode only.
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-14328-Dwyer-Mercoid-EDAW-N1E1-06T0-Pressure-Controller.aspx
